GO-PAP™ Question Title * 1. From what location on the generator, does the GO-PAP entrain ambient air? From the side of the mask Through the blue check valve From the distal end, around near where the oxygen tubing connects to the generator. It does not entrain ambient air OK Question Title * 2. How long will the GO-PAP run on a full D-cylinder? 7 minutes 40 minutes. 28 Minutes 35 minutes OK Question Title * 3. What is the flow rate and FiO2 of the GO-PAP? 90 LPM at 30% oxygen. 45 LPM at 30% oxygen 60 LPM at 30% oxygen OK Question Title * 4. Can a BVM connect to the BiTrac ED mask? Yes No OK Question Title * 5. Which competitive CPAP system is made in America? BLS Rescuer Flow-Safe O_Two None of the above OK Question Title * 6. What oxygen setting does the GO-PAP require? 12 LPM 8 LPM 10 LPM 15 LPM It varies OK Question Title * 7. What does the GO-PAP connect to on the regulator? The high pressure port The DISS port The low pressure Christmas Tree port The oxygen whip OK Question Title * 8. What is the GO-PAP PEEP setting, out of the package? 5 cmH20 7.5 cmH20 10 cmH20 OK Question Title * 9. What are the two ports on the mask for? For a leak valve For capnography readings For bleeding in additional oxygen, or gas sampling. All of the Above OK Question Title * 10. What should you do if the mask/cushion seal is leaking? Remove the mask Get a new mask Loosen the mask. Tighten the mask. OK Question Title * 11. Can I and should I use EtCO2 with the GO-PAP? YES and NO YES and YES NO and NO NO and YES OK Question Title * 12. True or False: you can add a nasal cannula to the GO-Pap to increase the FiO2 to around 45%. True False OK Question Title * 13. Can I put an exhalation filter on the GO-PAP? Yes No OK Question Title * 14. Can you nebulize with the GO-PAP with one tank? Yes No OK Question Title * 15. Where does the Neb-Connect connect to? Pig tail whip High Pressure Port Low pressure Christmas tree OK Question Title * 16. Can you turn the Neb-Connect ON and OFF? Yes No OK DONE