PSNI Video Training Quiz

Question Title

* 1. The most understood form of suction entrapment is:

Hair entrapment

Body entrapment

Limb entrapment

Evisceration

Mechanical entrapment

Question Title

* 2. The ASME/ANSI A112.19.9 suction entrapment testing standard was updated in 2007 to better address which of the following types of suction entrapment?

Hair entrapment

Body entrapment

Evisceration

a and b are correct

All the above (a-c)

Question Title

* 3. Hair entrapment danger is caused by:

Suction pipe depth is not 1.5 x the pipe diameter

Excessive flow

Single drain pool does not have a backup system

a and b are correct

a, b, and c are correct

Question Title

* 4. True or False: It is unlawful to sell suction outlet fittings that are not certified to the ANSI/ASME A112.19.8 or successor standard.

True

False

Question Title

* 5. True or False: The Consumer Product Safety Commission (CPSC) and States’ Attorneys General have the authority to enforce the Virginia Graeme Baker Act (VGB Act) and are required to do so.

True

False

Question Title

* 6. True or False: State and local laws cannot be more restrictive than the federal Virginia Graeme Baker Act (VGB Act).

True

False

Question Title

* 7. True or False: The majority of suction entrapment drownings are due to missing and broken drain covers.

True

False

Question Title

* 8. Which form(s) of suction entrapment are VGB Act backup system tested to address?

Hair entrapment

Body entrapment

Limb entrapment

Evisceration

Mechanical entrapment

b, c and d are correct

Question Title

* 9. True or False: The minimum standard for spacing between two pool drain covers is 3 feet measured from the center of each drain?

True

False

Question Title

* 10. Total dynamic head (TDH) is influenced by which of the following?

Filters

Heaters

Piping

Fittings

Both a and b are correct

All the above (a-d) are correct

Question Title

* 11. Designer system TDH calculations will:

Ensure compliance with the VGB Act

Under-estimate pump flow

Over-estimate pump flow

None of the above

Question Title

* 12. Unless otherwise specified by the manufacturer, there should be at least______diameters of straight pipe upstream from the flowmeter to correctly measure flow rate.

2 diameters

5 diameters

10 diameters

15 diameters

None of the above

Question Title

* 13. True or False: If not specified by the manufacturer, the minimum sump clearance should be 1.5 times the diameter of the pipe to be VGB Act compliant.

True

False

Question Title

* 14. To determine whether a drain cover is compliant with the VGB Act, an inspector should complete which of the following:

Visually inspect all drain covers for damage

Verify the drain cover installation date

Verify the manufacturer’s listed maximum flow rate

Verify the manufacturer’s listed sump depth

a and b are correct

All of the above (a-d) are correct.

Question Title

* 15. True or False: For a pool to be compliant with the VGB Act the main drain system flow rating must be equal to or greater than the minimum turnover flow rate of the pool?

True

False

Question Title

* 16. Address

Name

Company (if applicable)

City/Town

State/Province

Email Address