Skip to content
LMS: Starter System Diagnostics – Most Likely Repair Quiz
1.
What is the first step when diagnosing a no-crank condition?
Replace the starter
Check the battery voltage
Inspect the alternator
Replace the ignition switch
2.
What is the ideal open circuit voltage (OCV) for a fully charged battery?
10.5V
11.8V
12.6V
13.5V
3.
Why is voltage drop testing preferred over resistance (ohms) testing in starter circuits?
It is faster
It measures current flow directly
It detects resistance under load
It works without tools
4.
What is the maximum acceptable total voltage drop in a starter circuit?
0.1V
0.5V
1.0V
2.0V
5.
What does a repetitive clicking sound usually indicate?
Engine is seized
Starter is too powerful
Low battery voltage or insufficient current
Transmission issue
6.
What is measured during an amp draw test?
Voltage supply
Current used by the starter
Resistance in the wires
Fuel pressure
7.
What can high starter amp draw indicate?
Weak battery
Loose wiring
Mechanical resistance (e.g., engine hard to turn)
Low voltage
8.
What can low amp draw during cranking indicate?
Engine seizure
Strong battery
Electrical supply problem
Proper operation
9.
What happens if a starter is too far from the flywheel?
No sound at all
High-pitched whining during cranking
Engine stalls immediately
Increased fuel consumption
10.
Why is proper torque and clean installation important for a starter?
It improves fuel economy
It reduces tire wear
It ensures proper alignment and electrical grounding
It changes engine timing